Name : Non-contact AC Voltage Detector
-The AF-P10A is useful for identifying hot and neutral conductors, finding a break in a wire, and detecting the presence of ac voltage at outlets,switches, circuit breakers ,fuses,and wires and cables.
- Round cords may have twisted conductors .check for hot conductors by sliding the unit along the cord .
- The AF-P10A voltage detector can be used to find a break in a wire:
To find a break in a hot conductor ,trace the wire until the signal stops.
To find a break in a neutral conductor,connect a load between the hot and neutral .trace the wire until the signal stops.
-The voltage detector cannot detect voltage on armored cable;on sheathed nonmetallic cable that is saturated with water ,on shielded cable;or on cable in conduit,behind panels,or in metallic enclosures
Safe:non-contact design
Indicators : led and tone
Voltage range : AC 24V to 600V
Frequency range : 50Hz to 500Hz
Measurement category: category IV,600V per UL 61010
Operating conditions:
Temperature: 0 to 40C
Less than 80% relative humidity (noncondensing)
Altitude: 2000m maximum
Indoor use only
Pollution degree :2
Battery:two 1.5 volt batteries (AAA,NEDA24A or IEC LR03)
|
|
|
|
|
